Typical U values of building construction typical

U values (overall coefficient of heat transmission) indicate the heat flow through materials. While the values do vary for each particular material and method of construction, the following table gives general figures for some common modes of construction.

is the imperial unit for quoting U values while is the metric (SI) unit. When using these figures, make sure that the appropriate units for area and temperature difference are used.

(If you have any U values for other types of construction, e-mail us and we'll add them)

Wall (outer)	9" solid brick	0.38	2.2
	11" brick-block cavity - unfilled	0.18	1.0
	11" brick-block cavity - insulated	0.10	0.6
Wall (internal)	plaster, 4.5 inch brick, plaster	0.39	2.2
	plaster, 4 inch heavyweight block, plaster	0.44	2.5
	plaster, 4 inch lightweight block, plaster	0.22	1.2
	plasterboard, 4 inch studding, plasterboard	0,32	1.8
Floor (Ground)	solid concrete	0.14	0.8
	suspended - timber	0.12	0.7
Floors (Intermediate)	Plasterboard/ 8 inch joist space/ T&g boards - heat flow up	0.29	1.7
	Plasterboard/ 8 inch joist space/ T&g boards - heat flow down	0.25	1.4
Roof	pitched with felt, 50mm insulation	0.10	0.6
	pitched with felt, 100mm insulation	0.05	0.3
	flat, 25mm insulation	0.16	0.9
	flat, 50mm insulation	0.12	0.7
Window	wooden/uvpc frame, single glazed	0.88	5.0
	wooden/uvpc frame, double glazed	0.51	2.9
(the post April 2002 standard)	wooden/uvpc frame, double glazed - 20mm gap, Low-E	0.29	1.7
	metal frame, single glazed	1.02	5.8
Door	external solid timber	0.42	2.4
	external glazed	treat as glazing
	internal	assume the same as the wall

• multiply by 5.675 to convert to
  or
• divide by 5.675 to convert to